| Input | Micro series | KL12C-PDii |
| Operating Voltage | 198-264Vac 50Hz /60Hz |
| Rated Input Voltage | 220-240Vac 50Hz /60Hz |
| DC Input Voltage range | 200-240Vdc |
| Input Current | 0.08A Max. |
| Input Inrush Current | <15A (Half current pulse width100μs) @230Vac |
| Power factor(@230V100% load) | ≥ 0.93C |
| Total harmonic distortion | Typical: 18% (@230Vac, 100% load) |
| Stand-by power | ≤0.5W (@230Vac when PUSH or DALI turn off) |
| Efficiency(@230Vac,100% load) | 83% |
| Wiring Method | 0.75-1.5mm2 |
| Automatic circuit breaker | KL12C-PDii (Calculate current in the wire) |
| type | C10 | C13 | C16 | C20 | C25 |
| Number | 70 | 80 | 105 | 130 | 160 |
| type | B10 | B13 | B16 | B20 | B25 |
| Number | 40 | 50 | 65 | 85 | 100 |
| Output | Operating mode | Constant Current |
| Load type | LED |
| Ripple requirement (Flickering or Flickering-Free) | Flicker value: less than 2% for whole dimming range |
| Start up time | <1s (@230Vac,) |
| No-load output voltage | 30V DC Max. |
| Load output voltage range | 3-24V DC |
| Full load output power | 12W |
| Load output current | 350mA(3-24) 500mA(3-24) 550mA(3-22) 700mA(3-17) |
| Constant current/voltage Precision | Constant Current Precision ±5% |
| Wiring method | Push terminal, wire cross section:0.75-1.5mm2 |
| Control Method | Primary PUSH Dimming | Primary PUSH dimming (Max.lead length:20M) |
| DALI Dimming | DALI dimming (Max.lead length:300M) |
| Exception Protection Requirements | Output over temperature
protection | Yes, without self recovery function(Can be inquired) |
| Output short circuit protection | Yes, without self recovery function(Can be inquired) |
| Operating Environment | Operating temperature/ humidity | -25℃~50℃ Humidity:85% (Non-condensing) |
| Storage temperature/ humidity | -40℃~80℃, Humidity:10%–95% |
| Max. case temp(Tc) | 85℃ |
| Safety & EMC | EMC standard | EN55015 EN61547 EN61000-3-2 EN61000-3-3 |
| DALI protocol standard | IEC62386-102, IEC62386-207 DT6 |
| Safety standard | EN61347-1 EN61347-2-13 |
| Certification | ENEC CB CE |
| Withstand voltage | 3750Vac, 5mA, 60s (Input “L N”- Output “SEC”) |
| Others | Degrees of protection | IP20 |
| Type of protection | Class II |
| Installation type | Independent installation |
| With crimping | 88*52*25.5mm | 116*40.5*22mm | 136*42.5*24mm |
| Blackout memory function | Yes, PUSH blackout memory |
| PUSH dimming synchronization | 20 units Max. |
| Packaging requirement | Instruction+clapboard+outer carton(K=A) |
| Weight | 105g |
| Design life | 10 years ( @ Ta - 15 ℃) |
| Warranty | 5 years guarantee @Ta full load |
| Note: All parameters are tested at the input voltage of 230Vac and 25 degree environment unless specified. |
